INSPECTION DE CONDUITS – BioVac System

INSPECTION, CLEANING, AND DECONTAMINATION OF HVAC SYSTEM

BioVac System Inc. specializes in the inspection, cleaning, and decontamination of ventilation systems (HVAC) equipment, decontamination, mold, asbestos, and other contaminants and water damage restoration residential buildings, commercial, medical, industrial, and institutional.

We are certified by the NADCA (National Air Duct Cleaners Association) for the inspection of ventilation ducts (CVI: Certified Ventilation Inspector). We have the certification ASCS (Air System Certified Specialist) issued by NADCA.

The maintenance of the HVAC system begins with an inspection of the latter. Our technicians will be able to evaluate the health of your HVAC system (Level of dust control), that there had to be access or not. In fact, they will be able to install access doors, if needed, and will conduct the inspection with: Borescope, Robot Wolverine, Robot, Desert Storm, Duct-Eye (Bull's-Eye).

Our inspections will be documented in reports clear and precise, accompanied by videos(optional). Recommendations will be issued as necessary.

A proper maintenance of the HVAC system represents a key step in the process of improving the quality of indoor air. In fact, by neglecting this step, the contaminants that accumulate in the latter, are released back into the ambient air, thus contributing to the pollution of the indoor air.

The main purpose of cleaning air ducts of HVAC systems is to remove the contaminants (dust, debris, mold, mildew, and other) so that air can circulate on surfaces clean and restore the efficiency and effectiveness of systems, C. V. A. C.

We have the certification VSMR (Ventilation System Mold Remediator) issued by NADCA, to proceed with the cleanup of your HVAC system contaminated.

We use the principle of suction, friction, impulse in our cleaning process.

OCP Max

Wolverine

THE TWO METHODS THAT WE USE FOR OUR CLEANING PROJECTS ARE :

Traditional method :

This method is used for our residential projects in general. It is an efficient method and proven. During the cleaning process, we use a compressor, hoses, nozzles, whips and our dust-collectors (ELITE3, ELITE5). The cleaning also includes disinfection with safe products.

Specialized method :

This method is used for our projects in commercial, institutional and industrial. It involves the use of robots (Wolverine, Desert Storm) in addition to the compressor, hoses, nozzles, whips and our dust-collectors (ELITE3, ELITE5). For the isolation of the part to be cleaned, we use our balloons zoning (manufacturing by ourselves).The value of the robots is invaluable when it comes to access to areas difficult to access. The robot can anticipate and circumvent an obstacle to the need. Electric power tools and pneumatic tools each have their own source of energy, respectively, electricity and compressed air. Both contain rotating brushes to remove debris from the surface of the ducts. These are subsequently routed to the dust collector to negative air where they are vacuumed. The spraying devices are used to spray disinfectants and coatings. Airless sprayers are commonly used for this task. The solutions can be sprayed by a technician from a service point or by a carriage spray or a robot.